Carries Dante network audio to two analog XLR outputs

An adapter cable that converts digital audio from a Dante network into an analog line. It links the RJ45 input to a two-channel male XLR output and draws its power over PoE.

2 channelsAnalog output channels

1 x RJ45Input connector

2 x XLR maleOutput connector

500 mmCable length

100 MbpsNetwork speed

IP41Protection Grade

Key features

Two-channel analog outputTwo male XLR outputs spread the audio across two separate analog lines.

Audio performance+4 dBu output level, 20 Hz - 20 kHz frequency response and 100 dB dynamic range.

Channel separation100 dB channel separation and 0.25 dB channel matching keep the two outputs apart.

Dante audioHandles 44.1 kHz, 48 kHz and 96 kHz sample rates at 24 bit depth.

PoE powerDraws 2 W over Class 1 802.3af PoE and needs no separate power cable.

Operating environmentRated IP41 and works between -5 °C and +60 °C.

PoE power is required. The free Dante Controller software handles channel routing and device settings.

General
Part Number	RJD1212-0500
Description	Dante® audio to analogue audio adapter, 0x2, RJ45 input, 2 channel XLR output
Cable Length	500 mm
Input Connector	1 x RJ45 (Ethernet)
Output Connector	2x XLR Male
Software	Dante Controller (required, free)
Electrical
Power Consumption	< 2 Watt
Power over Ethernet (PoE) (Required)	Class 1 802.3af PoE PD compliant
Analogue Audio
Output Level (Balanced)	+4 dBu @ 12 dB headroom
Output Impedance	150 ohm balanced or 75 ohm unbalanced
Frequency Response	20 Hz – 20 kHz (-/+0.5 dB)
Dynamic Range	> 100 dB
Signal to Noise Ratio (S/N)	> 100 dB
Total Harmonic Distortion	< 0.05% at +4 dBu
Channel Separation	> 100 dB
Channel Matching	< 0.25 dB
Dante® Audio
Number of Channels	2 output channels
Sample Rate	44.1 kHz, 48 kHz (default), and 96 kHz
Bit Depth	24 bits
Network Speed	100 Mbps
Climatic
Protection Class	IP41
Operating Temperature	-5°C to +60°C (23°F to +140°F)
Mechanical
Insertion and Withdrawal Force	≥10N - ≤30N
Weight	192 g (0.423 lb)
Materials
Housing	PVC 60P Black

Amphe-Dante are Dante™ audio to analogue audio adapters, each with one RJ45 Dante input, and one and two (respectively) AX series XLR analogue outputs in a molded housing. Amphe-Dante products enable simple connection of analogue equipment to a Dante network and can receive audio channels from a Dante network and provide studio-quality, low-latency audio via an XLR connector to analogue audio equipment. Any audio available on the Dante network can be routed via the XLR outputs to an amplifier,
powered speaker, mixing console, digital signal processor (DSP), or other analogue audio device.