+90 212 222 87 80 nokta@noktaelektronik.net

B2B Вход Техническая служба

upTech

24 ports 10/100M POE Switch with 2 Gigabit Uplink IEEE802.3af/at 400W

Name: 24 ports 10/100M POE Switch with 2 Gigabit Uplink IEEE802.3af/at 400W
Brand: upTech
SKU: SW124FGP-A

Артикул: SW124FGP-A

Варианты

3 вариантов

Power400 W3

Port Count24 Port3

Сейчас показан: SW124FGP-A · 400 W · 24 Port

Gathers a mid-sized PoE network into one chassis.

24 PoE+ ports carry power and data over one cable to devices such as cameras, IP phones and wireless access points, and 2 Gigabit uplink ports connect the switch to the network backbone. Auto-detection determines the PoE requirement, the speed and the duplex mode of the powered device on its own.

26 Port24 PoE+ and 2 Gigabit uplink

390 WTotal PoE budget

30 WMax. PoE output per port

16 GbpsBandwidth

250 mPoE distance in Extend mode

-10°C ~ 45°COperating Temperature

Key features

30W

PoE+ output per port

It delivers 30 W per port to IEEE 802.3at powered devices and 15.4 W to IEEE 802.3af devices.

250m

Extend mode stretches the reach

With the DIP switch in Extend position, port speed drops to 10 Mbps and the switch carries PoE up to 250 meters.

16Gbps

Switching bandwidth

It works with a 4K-entry MAC address table and an 11.9 Mpps packet forwarding rate.

1000Mbps

Uplink speed

Ports 25-26 run at 10/100/1000M with auto-negotiation.

220V AC

Built-in power supply

It draws AC220V at 50/60 Hz from the mains and works with ±4 KV DC surge protection.

IN DAILY USE

No configuration neededIt works plug and play and asks for no management interface or setup software.

Fewer cables to pullCameras, IP phones and wireless access points need no separate outlet; power travels on the data cable.

Contains broadcast stormsVLAN mode isolates the ports from each other, so broadcast traffic from one camera does not reach the others.

ApplicationsIP cameras·WLAN access points·IP phones·Office access control systems

Network Specifications
PoE Port Priority	Supported
Bandwidth	16Gbps
MAC Address Table	4K
Diagnostics
LED Indicators	• PWR (Power indicator), PoE (PoE indicator), Link/Activity (Link/Activity indicator) • Extend Mode: Constantly on • Uplink: Constantly on when 25-26 ports are active; blinking indicates good data communication status. • Link: Constantly on when 1-24 ports are active; blinking indicates good data communication status.
Power Supply
PoE Standard	IEEE802.3 af/at
PoE Power Output (Per Port)	AF: 15.4W (IEEE 802.3af) AT: 30W (IEEE 802.3at)
Power Consumption	10W
Total Power	400W
Dimensions and Weight
Weight	3kg
Dimensions	285mm x 190mm x 44mm (W×D×H)
Environmental Conditions
Operating Temperature	-10°C ~ 45°C
Storage Temperature	-20°C ~ 70°C
Operating Humidity	5% ~ 95% Non-condensing
Storage Humidity	5% ~ 95% Non-condensing
Other Specifications
PoE	1-24 ports: 10/100M Auto-Negotiation RJ45
Uplink	25-26 ports: 10/100/1000M Auto-Negotiation RJ45
Maximum PoE Output Power	30W
PoE Budget	390W
PoE Transmission Distance	CAT6, 100m
Operation Mode	Store-and-Forward
Transmission Mode	IEEE802.3x Full Duplex and Backpressure Half Duplex
Dip Switch	Standard Mode 100m, VLAN + Extend Mode selection 250m
Packet Forwarding Rate	11.9Mpps
Supported Cables	UTP CAT5E or higher
Dip Switch	• VLAN • Extend
Input Voltage	AC220V. 50/60Hz
Surge Protection	±4KV DC
Standards Compliance	FCC, CE
IEEE 802.3af	Power over Ethernet
IEEE 802.3at	Power over Ethernet Plus
IEEE 802.3x	Flow Control
IEEE 802.3	10BASE-T
IEEE 802.3u	Fast Ethernet 100Base-TX
IEEE 802.3ab	Gigabit Ethernet 1000Base-T
IEEE802.3az	Energy Efficient Ethernet (EEE)

Datasheet

SW124FGP-A

pdf10/7/2022

Sertifika

CE RoHS Sertifikası

v1.0pdf9/29/2022

Fotoğraf

SW124FGP-A

jpg8/26/2025