Gathers a mid-sized PoE network into one chassis.
24 PoE+ ports carry power and data over one cable to devices such as cameras, IP phones and wireless access points, and 2 Gigabit uplink ports connect the switch to the network backbone. Auto-detection determines the PoE requirement, the speed and the duplex mode of the powered device on its own.
26 Port24 PoE+ and 2 Gigabit uplink
390 WTotal PoE budget
30 WMax. PoE output per port
16 GbpsBandwidth
250 mPoE distance in Extend mode
-10°C ~ 45°COperating Temperature
Key features
30W
PoE+ output per port
It delivers 30 W per port to IEEE 802.3at powered devices and 15.4 W to IEEE 802.3af devices.
250m
Extend mode stretches the reach
With the DIP switch in Extend position, port speed drops to 10 Mbps and the switch carries PoE up to 250 meters.
16Gbps
Switching bandwidth
It works with a 4K-entry MAC address table and an 11.9 Mpps packet forwarding rate.
1000Mbps
Uplink speed
Ports 25-26 run at 10/100/1000M with auto-negotiation.
220V AC
Built-in power supply
It draws AC220V at 50/60 Hz from the mains and works with ±4 KV DC surge protection.
IN DAILY USENo configuration neededIt works plug and play and asks for no management interface or setup software.
Fewer cables to pullCameras, IP phones and wireless access points need no separate outlet; power travels on the data cable.
Contains broadcast stormsVLAN mode isolates the ports from each other, so broadcast traffic from one camera does not reach the others.
ApplicationsIP cameras·WLAN access points·IP phones·Office access control systems
